BROBOXDB
Pololu Tic T825 USB Multi-Interface Stepper Motor Controller

primary

1 / 2

Catalog ID / P613094651815

Pololu Tic T825 USB Multi-Interface Stepper Motor Controller

Official Pololu product 3131: one bipolar stepper motor controller based on TI DRV8825; 8.5-45V; 1.5A per phase without cooling or 2.5A max with sufficient cooling. Interfaces: USB, TTL serial, I2C, analog, quadrature encoder, RC. Active and preferred.

Category
Controller
Type
controller / motor_driver
Manufacturer
Pololu
MPN
Tic T825 USB Multi-Interface Stepper Motor Controller

Key selection specs

Input voltage

8.5 V – 45 V

Motor channels

1

Board type

motor_driver

Interfaces

USB;TTL serial;I2C;analog;quadrature encoder;RC

Open datasheet

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

Pololu G2 High-Power Motor Driver 24v13

Pololu

Pololu G2 High-Power Motor Driver 24v13

Specification edge0%Tie
    View full comparison →
    Pololu Dual G2 High-Power Motor Driver 18v18 Shield for Arduino

    Pololu

    Pololu Dual G2 High-Power Motor Driver 18v18 Shield for Arduino

    Specification edge+50%Alternative ahead
    • Motor channelsCurrent1Alternative2
    View full comparison →
    Pololu G2 High-Power Motor Driver 24v13

    Pololu

    Pololu G2 High-Power Motor Driver 24v13

    Specification edge0%Tie
      View full comparison →
      Pololu G2 High-Power Motor Driver 24v21

      Pololu

      Pololu G2 High-Power Motor Driver 24v21

      Specification edge0%Tie
        View full comparison →

        Technical specs

        Start with the specs that decide fit and purchase.

        Controller board specs

        16
        Board kind
        motor driver
        Board architecture
        standalone board
        Primary application
        stepper_motion_control;CNC;robotics
        SDK available
        Yes
        Firmware updatable
        Yes
        UART interfaces
        1
        I2C interfaces
        1
        USB interfaces
        1
        Communication interfaces
        USB;TTL serial;I2C;analog;quadrature encoder;RC
        Control modes
        speed;position
        Motor drive
        stepper
        Phases
        2
        Control algorithm
        open_loop
        Encoder inputs
        1
        Encoder support
        quadrature
        Config Tool
        Pololu Tic Control Center

        Power / electrical specs

        3
        Input voltage (min)
        8.5 V
        Input voltage (max)
        45 V
        Protections
        driver current limiting

        Related Forum posts

        General Discussion posts attached to this part, newest first.

        Write a post about this part

        No linked posts yet.