Name: Pololu G2 High-Power Motor Driver 24v21
Brand: Pololu
SKU: P476335142633

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

Pololu

Pololu Dual G2 High-Power Motor Driver 18v18 Shield for Arduino

Specification edge+18%Alternative ahead

Motor channelsCurrent1Alternative2
Continuous output current / channelCurrent21 AAlternative18 A

View full comparison →

Pololu

Pololu G2 High-Power Motor Driver 24v13

Specification edge+19%Current part ahead

Continuous output current / channelCurrent21 AAlternative13 A

View full comparison →

Pololu

Pololu TB6612FNG Dual Motor Driver Carrier

Specification edge+50%Alternative ahead

Motor channelsCurrent1Alternative2

View full comparison →

Pololu

Pololu G2 High-Power Motor Driver 24v13

Specification edge+19%Current part ahead

Continuous output current / channelCurrent21 AAlternative13 A

View full comparison →

Technical specs

Start with the specs that decide fit and purchase.

Controller board specs

7

Board kind: motor driver
Board architecture: standalone board
Primary application: motor_driver;brushed_dc;high_power;robotics
SDK available: Yes
Firmware updatable: Yes
Control modes: pwm;direction
Motor drive: brushed dc

Power / electrical specs

5

Input voltage (min): 6.5 V
Input voltage (max): 40 V
Safety features: reverse_polarity;current_limiting
Protections: reverse_polarity;current_limiting
Safe Max Voltage Note: Pololu notes a safe maximum voltage of approximately 34V due to supply ripple/battery charge state.

Alternatives from the same part type, ranked by series, manufacturer, and shared specifications.

Pololu

Pololu Dual G2 High-Power Motor Driver 18v18 Shield for Arduino

Official specifications: Dual brushed DC motor shield; 6.5-30V; 18A continuous; discrete MOSFET H-bridges; current sensing/limiting; Arduino shield pin mappings customizable · Board kind: motor driver

Pololu

Pololu G2 High-Power Motor Driver 24v13

Official specifications: Single-channel brushed DC MOSFET H-bridge motor driver; 6.5-40V range; 13A continuous without heatsink; Pololu item 2992; Active and Preferred; 353 in stock at review · Board kind: motor driver

Pololu

Pololu TB6612FNG Dual Motor Driver Carrier

Official specifications: Tiny TB6612FNG dual motor driver carrier; two bidirectional DC motors or one bipolar stepper; 4.5-13.5V recommended motor voltage; 3A peak/1A continuous per channel; 593 in stock at review · Board kind: motor driver

Pololu

Pololu Tic 36v4 USB Multi-Interface High-Power Stepper Motor Controller

Official specifications: Stepper controller; 8-50V; up to approx 4A/phase without heat sink, 6A max with cooling; USB, TTL serial, I2C, analog, quadrature encoder, RC · Board kind: motor driver

Pololu

Pololu Tic T249 USB Multi-Interface Stepper Motor Controller

Official specifications: Toshiba TB67S249FTG stepper controller; 10-47V; approx 1.8A/phase no heat sink, 4.5A max with cooling; USB, TTL serial, I2C, analog, encoder, RC · Board kind: motor driver

Pololu

Pololu G2 High-Power Motor Driver 24v13

Board type: motor_driver · Motor drive: brushed_dc

Search part comparisons →