primary
1 / 3
Catalog ID / P739940690761
Holybro Pixhawk 6C
Official Holybro store page checked: SKU 11054; Pixhawk 6C; Pixhawk FMUv6C Open and Connector Standards; PX4 pre-installed; STM32H743 Arm Cortex-M7 up to 480 MHz; 2 MB flash/1 MB RAM; redundant Bosch/InvenSense IMUs and vibration isolation. USD 165.99 shown for the default Plastic controller / no…
- Category
- Controller
- Type
- controller / autopilot
- Manufacturer
- Holybro
- MPN
- 11054
Key selection specs
Input voltage
6 V
Logic voltage
3.3 V
SKU
11054
Standard
Pixhawk FMUv6C Open/Connector Standard
MCU
STM32H743 Arm Cortex-M7, up to 480 MHz
Memory
2 MB flash; 1 MB RAM
Compare similar parts
Parts in the same subcategory with shared normalized specifications.
Technical specs
Start with the specs that decide fit and purchase.
Controller board specs
21- Board kind
- autopilot
- Board architecture
- autopilot module
- Primary application
- drone;mobile_robot;autonomous_vehicle
- Processor vendor
- STMicroelectronics
- Processor
- STM32H743
- Processor architecture
- ARM Cortex-M7
- Processor cores
- 1
- Processor clock
- 480 MHz
- RAM
- 1 MB
- Flash
- 2 MB
- Firmware
- PX4
- SDK available
- Yes
- Firmware updatable
- Yes
- Connectors
- USB 4.75-5.25V; servo rail 0-36V; Pixhawk ports
- Communication interfaces
- MAVLink
- Compute board kind
- autopilot
- Microcontroller
- STM32H743
- Onboard IMU
- Yes
- Autopilot firmware
- PX4
- Ram Mb
- 1
- Onboard Flash Mb
- 2
Power / electrical specs
8- Input voltage (max)
- 6 V
- Usb Power Input Max V
- 5.25
- Usb Power Input Min V
- 4.75
- Servo Rail Input Max V
- 36
- Servo Rail Input Min V
- 0
- Telem1 Current Limiter A
- 1.5
- Pwm Signal Voltage Options
- 3.3V;5V
- Other Ports Combined Current Limiter A
- 1.5
Source specs
2- Firmware
- PX4 pre-installed
- IMU
- redundant Bosch/InvenSense IMUs with vibration isolation
Related Forum posts
General Discussion posts attached to this part, newest first.
No linked posts yet.