MyActuator RMD-X8 Pro

primary

1 / 6

Catalog ID / P100192

MyActuator RMD-X8 Pro

MyActuator RMD-X8 Pro actuator specifications: Rated torque: 13 Nm; Nominal voltage: 48 V; Gear ratio: 6/9/12:1.

Category: Actuator
Type: motor / qdd
Manufacturer: MyActuator
MPN: RMD-X8 Pro

Key selection specs

Rated torque

13 Nm

Rated speed

122 rpm

Nominal voltage

48 V

Gear ratio

6/9/12:1

Open source page Open Robot Model Editor

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

CubeMars / T-Motor

CubeMars / T-Motor AK80-9 V3.0 KV100

Specification edge+37%Alternative ahead

Rated torqueCurrent13 NmAlternative9 Nm
Maximum speedCurrent160 rpmAlternative570 rpm

View full comparison →

LKMTECH MG4010E-i10 V3

LKMTECH

LKMTECH MG4010E-i10 V3

Specification edge+16%Current part ahead

Rated torqueCurrent13 NmAlternative2.5 Nm
Maximum speedCurrent160 rpmAlternative320 rpm

View full comparison →

CubeMars / T-Motor

CubeMars / T-Motor AK10-9 V3.0 KV60

Specification edge+30%Alternative ahead

Rated torqueCurrent13 NmAlternative18 Nm
Maximum speedCurrent160 rpmAlternative235 rpm

View full comparison →

CubeMars / T-Motor AK70-10 KV100

CubeMars / T-Motor

CubeMars / T-Motor AK70-10 KV100

Specification edge+22%Current part ahead

Rated torqueCurrent13 NmAlternative8.3 Nm
Maximum speedCurrent160 rpmAlternative148 rpm

View full comparison →

Technical specs

Start with the specs that decide fit and purchase.

Motor specs

9

Motor kind: qdd actuator
Drive principle: BLDC/PMSM
Architecture: integrated_motor_reducer_driver
Max speed: 160 rpm
Gear type: planetary
Interface: CAN
Control modes: position;velocity;torque
Batch4 Source Note: RMD-X8 Pro snippets: 48V, 13Nm, 1:9, 122 rpm nominal, 160 rpm no-load.
Gear Ratio Options: 6/9/12

QDD actuator specs

3

QDD: Yes
Integrated driver: Yes
Recommended joint use: robot joint

Source specs

1

Communication: CAN;RS485

Related Forum posts

General Discussion posts attached to this part, newest first.

Write a post about this part

No linked posts yet.