BROBOXDB
No part image

Catalog ID / P100114

Hitec HS-5765MH

Hitec HS-5765MH actuator specifications: Stall torque: 25.0 / 347.17 @ 7.4V; Speed: 0.13 @ 7.4V; Width: 29.0mm.

Category
Actuator
Type
motor / rc_servo
Manufacturer
Hitec
MPN
HS-5765MH

Key selection specs

Stall torque

2.452 Nm

Nominal voltage

7.4 V

Stall torque

25.0 / 347.17 @ 7.4V

Speed

0.13 @ 7.4V

Width

29.0mm

Size/spline

Mega 15

Open source pageOpen Robot Model Editor

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

Hitec D71MH

Hitec

Hitec D71MH

Specification edge+56%Current part ahead
  • Stall torqueCurrent2.452 NmAlternative0.402 Nm
  • Stall torque @ 7.4VCurrent25 kg·cmAlternative4.1 kg·cm
View full comparison →
Hitec D131MW

Hitec

Hitec D131MW

Specification edge+54%Current part ahead
  • Stall torqueCurrent2.452 NmAlternative0.284 Nm
  • Stall torque @ 7.4VCurrent25 kg·cmAlternative2.9 kg·cm
View full comparison →
Hitec D141SH

Hitec

Hitec D141SH

Specification edge+40%Current part ahead
  • Stall torqueCurrent2.452 NmAlternative0.686 Nm
  • Stall torque @ 7.4VCurrent25 kg·cmAlternative7 kg·cm
View full comparison →
Hitec D145SW

Hitec

Hitec D145SW

Specification edge+50%Current part ahead
  • Stall torqueCurrent2.452 NmAlternative0.686 Nm
  • Stall torque @ 7.4VCurrent25 kg·cmAlternative7 kg·cm
View full comparison →

Technical specs

Start with the specs that decide fit and purchase.

Motor specs

9
Motor kind
rc servo
Drive principle
servo actuator
Architecture
rc_servo_module
Interface
PWM
Control modes
PWM servo
Stall Torque Kg Cm
25.0
Speed Sec Per 60deg
0.13
Classification Evidence
Hitec manufacturer spec chart
Hitec Chart Size Spline
Mega 15

RC servo specs

5
Servo signal
PWM
PWM pulse center
1500 us
Stall torque @ 7.4V
25 kg.cm
Speed @ 7.4V
0.13 s/60deg
Gear material
Metal

Related Forum posts

General Discussion posts attached to this part, newest first.

Write a post about this part

No linked posts yet.