BROBOXDB
Hitec HS-5245MG

primary

1 / 3

Catalog ID / P100109

Hitec HS-5245MG

Hitec HS-5245MG actuator specifications: Stall torque: 5.5 / 76.37 @ 6.0V; Speed: 0.12 @ 6.0V; Width: 16.8mm.

Category
Actuator
Type
motor / rc_servo
Manufacturer
Hitec
MPN
HS-5245MG

Key selection specs

Stall torque

0.539 Nm

Nominal voltage

6 V

Stall torque

5.5 / 76.37 @ 6.0V

Speed

0.12 @ 6.0V

Width

16.8mm

Size/spline

Standard 24

Open source pageOpen Robot Model Editor

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

Hitec D85MG

Hitec

Hitec D85MG

Specification edge+17%Current part ahead
  • Stall torqueCurrent0.539 NmAlternative0.422 Nm
  • Stall torque @ 6VCurrent5.5 kg·cmAlternative4.3 kg·cm
View full comparison →
Hitec D89MW

Hitec

Hitec D89MW

Specification edge+26%Alternative ahead
  • Stall torqueCurrent0.539 NmAlternative0.834 Nm
  • Stall torque @ 6VCurrent5.5 kg·cmAlternative8.5 kg·cm
View full comparison →
Hitec HS-40

Hitec

Hitec HS-40

Specification edge+52%Current part ahead
  • Stall torqueCurrent0.539 NmAlternative0.074 Nm
  • Stall torque @ 6VCurrent5.5 kg·cmAlternative0.75 kg·cm
View full comparison →
Hitec HS-53

Hitec

Hitec HS-53

Specification edge+41%Current part ahead
  • Stall torqueCurrent0.539 NmAlternative0.186 Nm
  • Stall torque @ 6VCurrent5.5 kg·cmAlternative1.9 kg·cm
View full comparison →

Technical specs

Start with the specs that decide fit and purchase.

Motor specs

9
Motor kind
rc servo
Drive principle
servo actuator
Architecture
rc_servo_module
Interface
PWM
Control modes
PWM servo
Stall Torque Kg Cm
5.5
Speed Sec Per 60deg
0.12
Classification Evidence
Hitec manufacturer spec chart
Hitec Chart Size Spline
Standard 24

RC servo specs

5
Servo signal
PWM
PWM pulse center
1500 us
Stall torque @ 6V
5.5 kg.cm
Speed @ 6V
0.12 s/60deg
Gear material
Metal

Related Forum posts

General Discussion posts attached to this part, newest first.

Write a post about this part

No linked posts yet.