BROBOXDB
Hitec D131MW

primary

1 / 2

Catalog ID / P100066

Hitec D131MW

Hitec D131MW actuator specifications: Stall torque: 2.9 / 40.27 @ 7.4V; Speed: 0.11 @ 7.4V; Width: 8.5mm.

Category
Actuator
Type
motor / rc_servo
Manufacturer
Hitec
MPN
D131MW

Key selection specs

Stall torque

0.284 Nm

Nominal voltage

7.4 V

Stall torque

2.9 / 40.27 @ 7.4V

Speed

0.11 @ 7.4V

Width

8.5mm

Size/spline

Micro

Open source pageOpen Robot Model Editor

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

Hitec D71MH

Hitec

Hitec D71MH

Specification edge+14%Alternative ahead
  • Stall torqueCurrent0.284 NmAlternative0.402 Nm
  • Stall torque @ 7.4VCurrent2.9 kg·cmAlternative4.1 kg·cm
View full comparison →
Hitec D141SH

Hitec

Hitec D141SH

Specification edge+42%Alternative ahead
  • Stall torqueCurrent0.284 NmAlternative0.686 Nm
  • Stall torque @ 7.4VCurrent2.9 kg·cmAlternative7 kg·cm
View full comparison →
Hitec D145SW

Hitec

Hitec D145SW

Specification edge+32%Alternative ahead
  • Stall torqueCurrent0.284 NmAlternative0.686 Nm
  • Stall torque @ 7.4VCurrent2.9 kg·cmAlternative7 kg·cm
View full comparison →
Hitec D485HW

Hitec

Hitec D485HW

Specification edge+32%Alternative ahead
  • Stall torqueCurrent0.284 NmAlternative0.735 Nm
  • Stall torque @ 7.4VCurrent2.9 kg·cmAlternative7.5 kg·cm
View full comparison →

Technical specs

Start with the specs that decide fit and purchase.

Motor specs

9
Motor kind
rc servo
Drive principle
servo actuator
Architecture
rc_servo_module
Interface
PWM
Control modes
PWM servo
Stall Torque Kg Cm
2.9
Speed Sec Per 60deg
0.11
Classification Evidence
Hitec manufacturer spec chart
Hitec Chart Size Spline
Micro

RC servo specs

5
Servo signal
PWM
PWM pulse center
1500 us
Stall torque @ 7.4V
2.9 kg.cm
Speed @ 7.4V
0.11 s/60deg
Gear material
Metal

Related Forum posts

General Discussion posts attached to this part, newest first.

Write a post about this part

No linked posts yet.