Part comparison

Flipsky Dual 75100 With Aluminum PCB Based on VESC vs MakerX Go-FOC DV6S

A side-by-side comparison of source-backed specifications within the same subcategory.

10 shared specs2 scored
FlipskyFlipsky Dual 75100 With Aluminum PCB Based on VESCVA-75D-N-100
View details
VS
MakerXMakerX Go-FOC DV6SGo-FOC DV6S
View details

Directional spec summary

Counts across 2 numeric specifications with a clear higher-or-lower direction.

Part A leads

0

Tied

1

Part B leads

1

These are metric-by-metric differences, not an overall performance score. Check the values below.

Specifications

10 specifications compared side by side.

AFlipskyFlipsky Dual 75100 With Aluminum PCB Based on VESC
BMakerXMakerX Go-FOC DV6S

Electrical1

Continuous output current / channel
Part A100 A
Part B180 A80 A higher

Control & communication9

Board kind
Part AVesc foc
Part BVesc foc
Board architecture
Part AStandalone board
Part BStandalone board
Primary application
Part Avesc_foc;dual_motor_driver;bldc;robotics
Part Bvesc_foc;dual_motor_driver;bldc;robotics
SDK available
Part AYes
Part BYes
Firmware updatable
Part AYes
Part BYes
ConnectorsUse-dependent
Part A4-20S battery input; USB/CAN/UART; 5V@1A BEC
Part BDual VESC6-based controller; high motor current 180A x2; XT90 plug included
Control modes
Part Atorque;velocity;position
Part Btorque;velocity;position
Motor drive
Part ABLDC foc
Part BBLDC foc
Motor channels
Part A2
Part B2

Product sources

Product sources used by this comparison

Flipsky Dual 75100 With Aluminum PCB Based on VESCOpen source
MakerX Go-FOC DV6SOpen source