Part comparison

Basicmicro RoboClaw Solo 30A, 34VDC Motor Controller vs Waveshare Servo Driver with ESP32

A side-by-side comparison of source-backed specifications within the same subcategory.

11 shared specs1 scored

Start over

BasicmicroBasicmicro RoboClaw Solo 30A, 34VDC Motor ControllerIMC408

View details

WaveshareWaveshare Servo Driver with ESP3221593

View details

Directional spec summary

Counts across 1 numeric specifications with a clear higher-or-lower direction.

Part A leads

Tied

Part B leads

These are metric-by-metric differences, not an overall performance score. Check the values below.

Specifications

11 specifications compared side by side.

Basicmicro RoboClaw Solo 30A, 34VDC Motor Controller / Waveshare Servo Driver with ESP32
Compare bySpecification	ABasicmicroBasicmicro RoboClaw Solo 30A, 34VDC Motor Controller	BWaveshareWaveshare Servo Driver with ESP32
Electrical2
Maximum input voltageUse-dependent	34 V	12 V
Logic voltage	3.3 V	3.3 V
Control & communication9
Board kind	Motor driver	Motor driver
Board architecture	Standalone board	Standalone board
Primary applicationUse-dependent	motor_driver;brushed_dc;closed_loop;robotics	motor_driver;servo_bus;robotics
SDK available	Yes	Yes
Firmware updatable	Yes	Yes
ConnectorsUse-dependent	single-channel 34VDC RoboClaw; USB/serial/RC/analog/microcontroller control	5.5x2.1mm DC 6-12V; servo voltage must match supply
Control modesUse-dependent	usb;ttl_serial;rc;pwm;analog	uart
Motor driveUse-dependent	Brushed DC	Servo drive
Motor channels	1	253252 higher

ABasicmicroBasicmicro RoboClaw Solo 30A, 34VDC Motor Controller

BWaveshareWaveshare Servo Driver with ESP32

Electrical2

Maximum input voltageUse-dependent

Part A34 V

Part B12 V

Logic voltage

Part A3.3 V

Part B3.3 V

Control & communication9

Board kind

Part AMotor driver

Part BMotor driver

Board architecture

Part AStandalone board

Part BStandalone board

Primary applicationUse-dependent

Part Amotor_driver;brushed_dc;closed_loop;robotics

Part Bmotor_driver;servo_bus;robotics

SDK available

Part AYes

Part BYes

Firmware updatable

Part AYes

Part BYes

ConnectorsUse-dependent

Part Asingle-channel 34VDC RoboClaw; USB/serial/RC/analog/microcontroller control

Part B5.5x2.1mm DC 6-12V; servo voltage must match supply

Control modesUse-dependent

Part Ausb;ttl_serial;rc;pwm;analog

Part Buart

Motor driveUse-dependent

Part ABrushed DC

Part BServo drive

Motor channels

Part A1

Part B253252 higher

Product sources

Product sources used by this comparison

Basicmicro RoboClaw Solo 30A, 34VDC Motor ControllerOpen source ↗

Waveshare Servo Driver with ESP32Open source ↗