Maximum input voltageUse-dependent
Part A34 V
Part B28 V
Part comparison
Basicmicro RoboClaw Solo 30A, 34VDC Motor Controller vs Waveshare DDSM Driver HAT (B)
A side-by-side comparison of source-backed specifications within the same subcategory.
10 shared specs1 scored
BasicmicroBasicmicro RoboClaw Solo 30A, 34VDC Motor ControllerIMC408VS
WaveshareWaveshare DDSM Driver HAT (B)29965Directional spec summary
Counts across 1 numeric specifications with a clear higher-or-lower direction.
Part A leads
0
Tied
1
Part B leads
0
These are metric-by-metric differences, not an overall performance score. Check the values below.
Specifications
10 specifications compared side by side.
| Compare bySpecification | ABasicmicroBasicmicro RoboClaw Solo 30A, 34VDC Motor Controller | BWaveshareWaveshare DDSM Driver HAT (B) |
|---|---|---|
| Electrical1 | ||
| Maximum input voltageUse-dependent | 34 V | 28 V |
| Control & communication9 | ||
| Board kind | Motor driver | Motor driver |
| Board architecture | Standalone board | Standalone board |
| Primary applicationUse-dependent | motor_driver;brushed_dc;closed_loop;robotics | motor_driver;direct_drive_servo;robotics |
| SDK available | Yes | Yes |
| Firmware updatable | Yes | Yes |
| ConnectorsUse-dependent | single-channel 34VDC RoboClaw; USB/serial/RC/analog/microcontroller control | DC5525 or XT60 power; DDSM400 9-28V, rated 25.2V; 24V 6A typical test supply |
| Control modesUse-dependent | usb;ttl_serial;rc;pwm;analog | json_command;uart |
| Motor driveUse-dependent | Brushed DC | Servo drive |
| Motor channels | 1 | 1 |
ABasicmicroBasicmicro RoboClaw Solo 30A, 34VDC Motor Controller
BWaveshareWaveshare DDSM Driver HAT (B)
Electrical1
Control & communication9
Board kind
Part AMotor driver
Part BMotor driver
Board architecture
Part AStandalone board
Part BStandalone board
Primary applicationUse-dependent
Part Amotor_driver;brushed_dc;closed_loop;robotics
Part Bmotor_driver;direct_drive_servo;robotics
SDK available
Part AYes
Part BYes
Firmware updatable
Part AYes
Part BYes
ConnectorsUse-dependent
Part Asingle-channel 34VDC RoboClaw; USB/serial/RC/analog/microcontroller control
Part BDC5525 or XT60 power; DDSM400 9-28V, rated 25.2V; 24V 6A typical test supply
Control modesUse-dependent
Part Ausb;ttl_serial;rc;pwm;analog
Part Bjson_command;uart
Motor driveUse-dependent
Part ABrushed DC
Part BServo drive
Motor channels
Part A1
Part B1
Product sources
Product sources used by this comparison
Basicmicro RoboClaw Solo 30A, 34VDC Motor ControllerOpen source ↗
Waveshare DDSM Driver HAT (B)Open source ↗