BROBOXDB
Adafruit Motor/Stepper/Servo Shield for Arduino v3 Kit

primary

1 / 1

Catalog ID / P601893354266

Adafruit Motor/Stepper/Servo Shield for Arduino v3 Kit

Adafruit Motor/Stepper/Servo Shield for Arduino v3 Kit controller specifications: Official specifications: Arduino motor/stepper/servo shield v3; TB6612 MOSFET drivers; 4 DC motors or 2 steppers; 1.2A per bridge, 3A peak ~20ms; 4.5-13.5V motor; I2C PWM driver; up to 32 stackable shields; Board…

Category
Controller
Type
controller / motor_driver
Variant
v3
Manufacturer
Adafruit
MPN
1438

Key selection specs

Input voltage

4.5 V – 13.5 V

Peak output current / channel

3 A

Official specifications

Arduino motor/stepper/servo shield v3; TB6612 MOSFET drivers; 4 DC motors or 2 steppers; 1.2A per bridge, 3A peak ~20ms; 4.5-13.5V motor; I2C PWM driver; up to 32 stackable shields

Open datasheet

Compare similar parts

Parts in the same subcategory with shared normalized specifications.

Adafruit TB6612 1.2A DC/Stepper Motor Driver Breakout Board

Adafruit

Adafruit TB6612 1.2A DC/Stepper Motor Driver Breakout Board

Specification edge0%Tie
    View full comparison →
    Adafruit DRV8833 DC/Stepper Motor Driver Breakout Board

    Adafruit

    Adafruit DRV8833 DC/Stepper Motor Driver Breakout Board

    Specification edge+33%Current part ahead
    • Peak output current / channelCurrent3 AAlternative2 A
    View full comparison →
    DFRobot Fermion 2x1.2A DC Motor Driver (TB6612FNG)

    DFRobot

    DFRobot Fermion 2x1.2A DC Motor Driver (TB6612FNG)

    Specification edge+6%Alternative ahead
    • Peak output current / channelCurrent3 AAlternative3.2 A
    View full comparison →
    DFRobot SimpleFOCmini Brushless DC Motor Driver Board

    DFRobot

    DFRobot SimpleFOCmini Brushless DC Motor Driver Board

    Specification edge+17%Current part ahead
    • Peak output current / channelCurrent3 AAlternative2.5 A
    View full comparison →

    Technical specs

    Start with the specs that decide fit and purchase.

    Controller board specs

    6
    Board kind
    motor driver
    Board architecture
    standalone board
    Primary application
    motor_driver;brushed_dc;stepper;servo;arduino_shield;robotics
    SDK available
    Yes
    Firmware updatable
    Yes
    Motor drive
    multi mode

    Power / electrical specs

    2
    Input voltage (min)
    4.5 V
    Input voltage (max)
    13.5 V

    Related Forum posts

    General Discussion posts attached to this part, newest first.

    Write a post about this part

    No linked posts yet.